series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 1 of 10 north america only features: models single output model max output power (w) output voltage range (v) output current (a) input voltage (vac/hz) input voltage (vdc) mode of operation efficiency (%) amer120 - 50250c az 125 36-50 0 - 2.5 90- 305/47- 440 120- 430 constant current 91 constant voltage 90 amer120 - 36340c az 122.4 24-36 0 - 3.4 90- 305/47- 440 120- 430 constant current 90 constant voltage 89 amer120 - 24500c az 120 12-24 0 -5 90- 305/47- 440 120- 430 constant current 89 constant voltage 87 add suffi x - f no dimming option exceeding the maximum output power will permanently damage the converter the dimming feature is not supported when units are used in constant voltage mode only, aimtec suggests to order - f no dimming option in this case. in constant current mode output current is maximum shown, in constant voltage mode output voltage is the maximum shown. note: all specifications in this datasheet are measured at an ambient temperature of 25c, humidity< 75%, nominal input voltage and at rated output load unless otherwise specified. i nput specifications parameters conditions typical maximum units inrush current <2ms 115vac 45 a 230vac 60 leakage current 115vac 0. 5 ma 230vac 0. 75 ac current 11 5vac 1. 8 a 230vac 0. 7 power factor 115vac 0. 98 240vac 0. 94 external fuse 250v/ 3a start up time 9 00 ms surge voltage 2sec 440 v output specifications parameters conditions typical maximum units current accuracy 3 % line regulation ll - hl 1 % load regulation 0 - 100% load 3 % ripple & noise 20mhz bandwidth 100 mv p - p hold - up time 80 m s current adjustment range 100 - 0 % minimum load voltage see the models table tested with 0.1f (m/c) or (c/c) and 47f (e/c) parallel capacitors at the end. ? constant current or constant voltage led driver or converter ? over temperature protection ? over current protection ? input range 90 - 305 vac/47 - 440hz ? waterproof case rated ip6 8 ? high efficiency up to 9 1 % ? power factor correction ? 115vac operating te mperature - 5 0 to 8 5 c ? 230vac operating temperature - 55 to 85c ? dimming via analog / 0 - 10v dimming ? s hort c ircuit p rotection
series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 2 of 10 north america only isolation specifications parameters conditions typical rated units tested i/ p - o/p voltage 3sec 3 750 v ac tested i/p - fg voltage 3sec 1880 vac tested o/p - fg voltage 3sec 500 vac isolation resistance 500vdc >1000 m isolatio n capacitance 1000 pf general specifications parameters conditions typical maximum units switching frequency 100 khz over current protection 110% of iout over voltage protection 110% of vout short circuit protection continuous short circui t restart auto recovery over temperature protection >105c operating temperature ( see derating table ) (115vac) - 5 0 to +85 o c (230vac) - 55 to +85 o c cold start - up time - 55c 30 sec maximum case temperature 100 o c storage temperature - 55 to +95 o c temperature coefficient 0.02 % / o c cooling free air convection humidity 95 % rh case material aluminum potting epoxy (ip68 rated) wires ul1015 18awg input & 14awg output *20cm weight 750 g dimensions (l x h x w) 7.13 x 2.32 x 1.85 inche s 181.00 x 59.00 x 47.00 mm mtbf >400,000 hrs (mil - hdbk - 217f at +25c) safety specifications parameters agency approvals ce standards en55022, class b, en60529(ip68), en61347 - 1, en61347 - 2 - 13 note : also designed to mee t culus, ul8750, ul60950 - 1
series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 3 of 10 north america only dimensions 59 . 00 ( 2 . 32 ) 181 . 00 ( 7 . 13 ) 47 . 00 ( 1 . 85 ) 200 . 00 ( 8 . 00 ) 200 . 00 ( 8 . 00 ) 2 . 30 ( 0 . 09 ) end view top view side view input / output wires are 18 awg 20 cm 41 . 00 ( 1 . 73 ) 8 . 00 ( 0 . 32 ) 11 . 00 ( 0 . 43 ) 4 . 00 ( 0 . 16 ) 23 . 00 ( 0 . 91 ) measurements in millimeters ( inch ) case tolerance : 0 . 5 ( 0 . 02 ) 27 . 00 ( 1 . 06 ) analog (resistive) dimming application circuit model number maximum pot value (k) amer120 - 50250 c az 18.22 amer120 - 36340 c az 2 2.10 amer120 - 24500 c az 34.31 am er 120 - az n 1 st led + vout 1 1 - vout red black ac blue l brown green blue white pot
series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 4 of 10 north america only 0 - 10v dimming application circuit 0-10vdc gnd r28 1k5, 0805 +vs (blue) -vs (white) u1 ltv-817c pin 1 pin 2 derating - 55 - 30 0 20 40 60 80 100 100 80 60 40 20 0 safe operating area output power (%) ambient temperature o c free air convection 50 c 5 c cv mode cc mode 50 c 0 c 230 vac
series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 5 of 10 north america only e fficiency vs. input voltage and output current (cc load) amer120 - 50250 c az amer120 - 36340 c az
series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 6 of 10 north america only efficiency vs. input voltage and output current (cc load) continued amer120 - 24500 c az pfc value vs. output load current (cc load) amer120 - 50250 c az
series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 7 of 10 north america only pfc value vs. output load current (cc load) amer120 - 36340 c az amer120 - 24500 c az
series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 8 of 10 north america only constant current mode vs. constant voltage mode amer120 - 50250 c az amer120 - 36340 c az
series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 9 of 10 north america only constant current mode vs. constant voltage mode amer120 - 24500 c az ou tput current vs. radj amer120 - 50250 c az
series am er120 -c az up to 5a | ac- dc / dc - dc | led driver / converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r3.d 10 of 10 north america only output current vs. r adj amer120 - 36340 c az amer120 - 24500 c az note: 1. datasheets are updated as needed and as such, specifications are subject to change without notice. once printed or downloaded, datasheets are no longer controlled by aimtec; refer to www.aimtec .com for the most current product specifications. 2. product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. mechanical drawings and specifications are for reference only. 4. all specifications are measured at an ambient temperature of 25c, humidity<75%, nominal input voltage and at rated output load unless otherwise specifie d. 5. aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. cas numbers and other limited information are considered proprietary and may not be available for release. 6. this product is not designed for use in critical life support systems, equipment used in hazardous enviro nments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. warranty is in accordance with aimtecs standard terms of sale available at www.aimtec.com.
|
